Nuvo NV-T2DF Bedienungsanleitung

Antenna InputThe T2 ships with a proprietary amplified AM/FM antenna. This antenna is designed to work only with the NuVo T2 series tuners. It can be

II. Front Panel Menu ControlsThe T2 has many settings available in the menus. This allows for many specialized set up options for basic tuner operatio

The following menu selections are not necessary for standard tuner operation, but do provide a deeper level of control for those who need it. When you

Audio Settings These selections are intended for some stand-alone applications. They should be left at default settings for NuVo audio systems. These

AUX InputDisable/Enable: The T2 has an auxiliary audio input that allows access through either of the tuners to an additional audio source. To use th

III. Stand-alone Front Panel Use of the T2Tuning a Desired Station: Pressing the Select knob cycles through the tuning modes.Step Tune Mode: Each of

Actual use of these data fields is not regulated, and they may vary significantly in content between stations. If you choose not to have RDS informati

IV. Using the T2 with the Concerto NuVoNetSetting Up the Tuner for NuVoNetThe T2 must be set for one of the Concerto source inputs 1-6. This can be do

Operating the T2 with the Concerto Display Pad By following the previous steps you should now be able to operate the T2 from any of the Concerto Dis

T2 Configuration SoftwareBasic setup and operation of the T2 is easily done from the front panel, the included T2RC3 remote, or the Concerto Display P

ENGLISHDangerExposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably to noise induced hearing loss b

2.2 Regional Setup2.3 Brightness2.4 Auto-OnPage 202.2 Regional Setup: Depending on your geographic location, the tuner needs to be set for the proper

3.3 Rename Bank3.4 Erase Bank3.2 Add BankPage 213.2 Add Bank: If you want to add a bank of 10 presets, the “Add Bank “ button will bring up a window

4.1 Custom Regional SetupPage 224.1 Custom Regional Setup: Some countries operate at a tuning standard outside the four preset regions. The Custom se

4.5 AUX InputPage 234.5 AUX Input: The T2 has an additional input that allows an external device to be controlled through the T2's IR pass throu

Page 246.1 Categories Tab6.2 FM Freqs: This tab lists all the available frequencies within the FM band. When highlighted, the Frequency Information o

Page 25 7.2 Successful Download: When the download is complete a final window will appear indicating that all the information has downloaded

GROUNDCLAMPSGROUNDCLAMPSELECTRICSERVICE ENTRANCEELECTRICSERVICE ENTRANCEANTENNA DISCHARGE UNIT NEC SECTION810-20GROUNDING CONDUCTORSANTENNA DISCHARGE

LLOUTAUX INRRTRIGGERON=+12V AUDIOOUTPUTTUNER B TUNER AOUT AUDIOOUTPUTRS 232ANTENNA INPUTIN USE ONLY NuVo NV-T2PASPOWER

Front Panel 1. Stand-by LED: This LED (Light Emitting Diode) indicates that the T2 is plugged into an AC power source.2. Remote Sensor: This

Back Panel 1. Antenna Input: Coax “F” connector brings in the signal input from the NuVo NV-T2PAS antenna (pg. 10).2. Aux. Input: This stereo

NV-T2RC3 Remote Control 1. Power: The power button turns the selected tuner on and off. 2. Scroll Buttons: These buttons are the equivalent

I. Installing the NV-T2DF Dual TunerStereo Audio ConnectionsEach tuner has two audio output jacks. One is a stereo RCA connection, and the other is a

IR Pass-ThruThe mini jack labeled “IR pass-thru" mini connection is used for connecting forwarded IR signals to an audio component connected to t